// SPDX-License-Identifier: MIT
// Copyright (c) 2026 Incoprea
// Miter extension at a path corner
// Not compiled or tested in-world
// Setup: Put in a spare owned prim. Set bend angle0..170 degrees and positive half-width. Touch to print the plan privately.
// Stop / restore: Remove/disable; calculations do not alter objects.
// Notes: Sharp bends create long miters; the example reports a miter-limit ratio before actual construction.
// License: see LICENSE in this distribution.
// Original Incoprea. MIT. Calculation only.
float BEND=70.0;
float HALF_WIDTH=0.8;
default
{
    touch_start(integer detectedCount)
    {
        if(llDetectedKey(0)!=llGetOwner())return;
        if(BEND<0.0||BEND>=170.0||HALF_WIDTH<=0.0)
        {
            llOwnerSay("Invalid angle/width.");
            return;
        }
        float length=HALF_WIDTH/llCos(BEND*DEG_TO_RAD*0.5);
        llOwnerSay("Miter length="+(string)length+" ratio="+(string)(length/HALF_WIDTH)+" outer extension="+(string)(HALF_WIDTH*llTan(BEND*DEG_TO_RAD*0.5)));
    }
}